FIELD OF APPLICATION
• The material is used for repair and sealing seams and junctures of different roof and waterproofing cloths, , air tubes, ;
• Waterproofing, heat proofing and repairing of , , door units and window frames;
• Vibration and sound insulation of .
High adhesive rate to all kinds of bases (metal, concrete, wooden, polymer)
High adhesive rate to all kinds of bases
Protection against corrosion
The technical lifetime is 25-30 years
Resistance to mechanical influences at low temperatures
DESCRIPTION
• Multipurpose self-adhesive sealing tape Rizolin FS, AS is made of reinforced, tear-resistant fiberglass cloth impregnated with bitumen and polymeric composition.
• FS type sealing tape is made with an aluminium foil protective layer,
• AS type sealing tape is self-adhesive from both sides.
• The material is waterproof, resistant to mechanical influences, rapid changes of temperature, ultraviolet influence and corrosion.
Can be applied in all climatic zones (according to SNiP 23-01-99).
METHOD OF INSTALLATION
(according to «Guideline for installation of roofs of self-adhesive rolled waterproofing material «RIZOLIN»)
The material is easy in application and does not require any special equipment. To apply Rizolin sealing tape one must only take off the release film, place the material onto a dry, dust-free surface and roll it down with a roller (SNiP 3.04.01-87)
ATTENTION: Self-adhesive properties of the material retain at an air temperature above +15 °С. At lower temperatures a little heat must be applied to the adhesive side till the appearance of oily luster in order to ensue the adhesiveness (according to SNiP II -26-76*).
DO NOT heat the material from foil side!
Basic physical and mechanical characteristics of Rizolin FS, AS sealing tape
Item
FS
AS
Thickness, mm.
2,5 ± 0,15
2,5 ± 0,15
Breaking force under tension in longitudinal/transverse directions, not less
1100/1100
1100/1100
Adhesive strength, not less, kN/m
— from steel surface
1,5
1,5
— from concrete surface
1,0
1,0
— from wooden surface
0,5
0,5
Thermal resistance within 2 hours in the upright position, °С, not less
+70 ÷+80
+70 ÷ +80
Radius of curvature temperature (25±2) mm, °С, not above
-35
-35
Water absorption, %, less than
1
1
Operating temperature, °С
-50 ÷ +50
-50 ÷ +50
Vapor resistance, mg/(m*h*Pa)
20
20
Waterproofing under a pressure not less than 0,2 MPa within 2 hours
absolute
absolute
Waterproofing under a pressure not less than 0,5 MPa within 10 min.
Contact us via : mail@rizolin.ru
Sealing Tape FS, AS
Sealing Tape FS, AS
FIELD OF APPLICATION
• The material is used for repair and sealing seams and junctures of different roof and waterproofing cloths, , air tubes, ;
• Waterproofing, heat proofing and repairing of , , door units and window frames;
• Vibration and sound insulation of .
High adhesive rate to all kinds of bases (metal, concrete, wooden, polymer)
High adhesive rate to all kinds of bases
Protection against corrosion
The technical lifetime is 25-30 years
Resistance to mechanical influences at low temperatures
DESCRIPTION
• Multipurpose self-adhesive sealing tape Rizolin FS, AS is made of reinforced, tear-resistant fiberglass cloth impregnated with bitumen and polymeric composition.
• FS type sealing tape is made with an aluminium foil protective layer,
• AS type sealing tape is self-adhesive from both sides.
• The material is waterproof, resistant to mechanical influences, rapid changes of temperature, ultraviolet influence and corrosion.
Can be applied in all climatic zones (according to SNiP 23-01-99).
METHOD OF INSTALLATION
(according to «Guideline for installation of roofs of self-adhesive rolled waterproofing material «RIZOLIN»)
The material is easy in application and does not require any special equipment. To apply Rizolin sealing tape one must only take off the release film, place the material onto a dry, dust-free surface and roll it down with a roller (SNiP 3.04.01-87)
ATTENTION: Self-adhesive properties of the material retain at an air temperature above +15 °С. At lower temperatures a little heat must be applied to the adhesive side till the appearance of oily luster in order to ensue the adhesiveness (according to SNiP II -26-76*).
DO NOT heat the material from foil side!
Basic physical and mechanical characteristics of Rizolin FS, AS sealing tape
USED IN SOLUTIONS:
SELECT SOLUTION:
SELECT MATERIAL: